Nissan Murano: Standard maintenance / Emission control system maintenance

Nissan Murano 2015-2024 Owners Manual / Maintenance and schedules / Standard maintenance / Emission control system maintenance

Abbreviations: I = Inspect and correct or replace as necessary, R = Replace

Nissan Murano. Emission control system maintenance

Nissan Murano. Emission control system maintenance

NOTE:

(1) After 40,000 miles (64,000 km) or 48 months, inspect every 10,000 miles (16,000 km) or 12 months. Replace the drive belt if found damaged.

(2) If operating mainly in dusty conditions, more frequent maintenance may be required.

(3) Periodic maintenance is not required.

(4) First replacement interval is 105,000 miles (168,000 km) or 84 months. After first replacement, replace every 75,000 miles (120,000 km) or 60 months.

(5) Use only Genuine NISSANLong Life Antifreeze/Coolant (blue) or equivalent with proper mixture ratio of50%antifreeze and50% demineralized or distilled water. Mixing any other type of coolant or the use of non-distilled water may reduce the life expectancy of the factory fill coolant.

(6) Replace spark plug when the plug gap exceeds 0.053 in (1.35 mm) even if within specified periodic replacement mileage.

(7) Periodic maintenance is not required. However, if valve noise increased, inspect valve clearance.

* Maintenance itemsandintervals with “*” are recommendedby NISSANfor reliable vehicle operation.Theownerneednot perform such maintenance in order to maintain the emission warranty or manufacturer recall liability. Other maintenance items and intervals are required.

    Standard maintenance

    The following tables show the standard maintenance schedule. Depending upon weather and atmospheric conditions, varying road surfaces, individual driving habits and vehicle usage, additional or more frequent maintenance may be required...

    Chassis & body maintenance

    Abbreviations: I = Inspect and correct or replace as necessary, R = Replace, NOTE: Maintenance items with “ ” should be performed more frequently according to “Maintenance under severe driving conditions”...

    Other information:

    Nissan Murano 2015-2024 Owners Manual: Checking engine coolant level


    Check the coolant level in the reservoir when the engine is cold. If the coolant level is below the MIN level , add coolant to the MAX level . If the reservoir is empty, check the coolant level in the radiator when the engine is cold. If there is insufficient coolant in the radiator, fill the radiator with coolant up to the filler opening and also add it to the reservoir up to the MAX level ...

    Nissan Murano 2015-2024 Owners Manual: Brake fluid


    WARNING Use only new fluid from a sealed container. Old, inferior or contaminated fluid may damage the brake system. The use of improper fluids can damage the brake system and affect the vehicle’s stopping ability. Clean the filler cap before removing...

    Categories

    Driver and passenger supplemental knee air bag

    Nissan Murano. Driver and passenger supplemental knee air bag

    Driver’s side

    The knee air bag is located in the knee bolster, on the driver’s and passenger’s side. All of the information, cautions and warnings in this manual apply and must be followed. The knee air bag is designed to inflate in higher severity frontal collisions, although it may inflate if the forces in another type of collision are similar to those of a higher severity frontal impact. It may not inflate in certain collisions.

    Nissan Murano. Driver and passenger supplemental knee air bag

    Passenger’s side

    read more

     
    Copyright © 2024 www.nimurano.com