Nissan Murano: Child restraints / Installing top tether strap
Rear bench seat
Top tether strap
Anchor point
The child restraint top tether strap must be
used when installing the child restraint with
the LATCH lower anchor attachments.
First, secure the child restraint with the
LATCH lower anchors.
Rear bench seat
OUTBOARD SEATING POSITIONS
- Remove the head restraint/headrest
and store it in a secure place. Be sure to
reinstall the head restraint/headrest
when the child restraint is removed. For
additional information, refer to “Head
restraints/headrests” in this section.
- Position the top tether strap
as
shown.
- Secure the tether strap to the tether
anchor point as shown.
Tighten the tether strap according to
the manufacturer’s instructions to remove
any slack.
If you have any questions when installing
a top tether strap, it is recommended
that you visit a NISSAN dealer for this
service.
WARNING
Child restraint anchorages are designed
to withstand only those loads
imposed by correctly fitted child restraints.
Under no circumstances are
they to be used to attach adult seat
belts, or other items or equipment to
the vehicle. Doing so could damage the
child restraint anchorages. The child restraint
will not be properly installed using
the damaged anchorage, and a
child could be seriously injured or killed
in a collision.
For additional information, refer to allWarnings
and Cautions in the “Child safety” and
“Child restraints” sections of this manual
before installing a child restraint...
WARNING
The three-point seat belt with Automatic
Locking Retractor (ALR) must be
used when installing a child restraint.
Failure to use the ALRmodewill result in
the child restraint not being properly
secured...
Other information:
Type A (if so equipped)
The button will be on the NISSAN
Intelligent
Key® if the vehicle has Remote Engine
Start. This feature allows the engine to
start from outside the vehicle.
The following features may be affected
when the Remote Engine Start feature is
used:
Type B (if so equipped)
Vehicles with an automatic climate
control system will default to either
heating or cooling mode...
Move the shift lever to the P (Park) position,
place the ignition switch in the
LOCK position and make sure you carry
the Intelligent Key with you.
Close the driver’s door and press the
driver’s door request switch OR close
all doors and press any door request
switch while carrying the Intelligent Key
with you...