Nissan Murano: Heater and Air Conditioner (automatic) / Manual operation
Fan speed control
Press the 
fan speed control
buttons
to manually control the fan speed.
Press the AUTO button to return to automatic
control of the fan speed.
Temperature control dial
The temperature control dial allows you to adjust the temperature of the outlet air. To lower the temperature, turn the dial to the left. To increase the temperature, turn the dial to the right. Temperature can be adjusted on the driver’s and passenger’s side.
Air recirculation
Press the 
air recirculation
button to
recirculate interior air inside the vehicle.
The 
indicator light on the button
will
come on.
The air recirculation cannot be activated
when the air conditioner is in the 
front defrosting mode.
When the outside temperature exceeds 70°F (21°C), the air conditioning system may default to air recirculation mode automatically to reduce overall power consumption. To exit air recirculation mode, select the fresh air intake button to enter fresh air mode.
Fresh air intake
Press the 
fresh air intake
button to
draw outside air into the passenger compartment.
A/C (air conditioner) button
Start the engine, press the 
fan
speed
control buttons to the desired position and
press the 
button to turn on the air
conditioner. To turn off the air conditioner,
press the 
button again.
The air conditioner cooling function operates only when the engine is running.
Air flow control
Pressing the MODE button manually controls air flow and selects the air outlet:
Air flows mainly from center
and side vents.
Air flows mainly from center
and side vents and foot
outlets.
Air flows mainly from foot
outlets
and partly from defroster.
Air flows mainly from defroster
and foot outlets.
To turn system off
Press the ON-OFF button.
Rear window and outside mirror
(if so equipped) defroster switch For additional information, refer to “Rear window and outside mirror (if so equipped) defroster switch” in the “Instruments and controls” section of this manual.
Remote Engine Start with Intelligent Climate Control (if so equipped)
Vehicles equipped with automatic climate
controls and Remote Engine Start function
may go into automatic heating or cooling
mode when Remote Engine Start is activated
depending on outside and cabin
temperatures...
Operating tips
Sensors, and
on the instrument
panel, help the system maintain a constant
temperature. Do not put anything on or
around these sensors.
When the climate system is in automatic
operation and the engine coolant
temperature and outside air temperature
are low, the air flow outlet may default
to defroster mode for a maximum
of 2 minutes and 30 seconds...
Other information:
Nissan Murano 2015-2024 Owners Manual: Vehicle Dynamic Control (VDC) OFF switch
The vehicle should be driven with the VDC system on for most driving conditions. If the vehicle is stuck in mud or snow, the VDC system reduces the engine output to reduce wheel spin. The engine speed will be reduced even if the accelerator is depressed to the floor...
Nissan Murano 2015-2024 Owners Manual: Vehicle-to-vehicle distance control mode
In the vehicle-to-vehicle distance control mode, the ICC system automatically maintains a selected distance from the vehicle traveling in front of you according to that vehicle’s speed (up to the set speed), or at the set speed when the road ahead is clear...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Vehicle Dynamic Control (VDC) OFF switch
- Warning lights
- Indicator lights
- New on site
- Most important about car
Driver and passenger supplemental knee air bag
Driver’s side
The knee air bag is located in the knee bolster, on the driver’s and passenger’s side. All of the information, cautions and warnings in this manual apply and must be followed. The knee air bag is designed to inflate in higher severity frontal collisions, although it may inflate if the forces in another type of collision are similar to those of a higher severity frontal impact. It may not inflate in certain collisions.
Passenger’s side
