Nissan Murano: Child restraints / Precautions on child restraints
WARNING
Failure to follow the warnings and instructions
for proper use and installation
of child restraints could result in
serious injury or death of a child or
other passengers in a sudden stop or
collision:
- The child restraint must be used
and installed properly. Always follow
all of the child restraint manufacturer’s
instructions for installation
and use.
- Infants and children should never
be held on anyone’s lap. Even the
strongest adult cannot resist the
forces of a collision.
- Do not put a seat belt around both
a child and another passenger.
- NISSAN recommends that all child
restraints be installed in the rear
seat. Studies show that children
are safer when properly restrained
in the rear seat than in the front
seat. If you must install a forwardfacing
child restraint in the front
seat, refer to “Forward-facing child
restraint installation using the seat
belts” in this section.
- Even with the NISSAN Advanced Air
Bag System, never install a rearfacing
child restraint in the front
seat. An inflating air bag could seriously
injure or kill a child. A rearfacing
child restraint must only be
used in the rear seat.
- Be sure to purchase a child restraint
that will fit the child and vehicle.
Some child restraints may
not fit properly in your vehicle.
- Child restraint anchorages are designed
to withstand only those
loads imposed by correctly fitted
child restraints. Under no circumstances
are they to be used to attach
adult seat belts, or other items
or equipment to the vehicle. Doing
so could damage the child restraint
anchorages. The child restraint
will not be properly installed
using the damaged
anchorage,and a child could be seriously
injured or killed in a
collision.
- Never use the anchor points for
adult seat belts, or other items.
- A child restraint with a top tether
strap should not be used in the
front passenger seat.
- Keep seatbacks as upright as possible
after fitting the child
restraint.
- Infants and children should always
be placed in an appropriate child
restraint while in the vehicle.
When the child restraint is not in use,
keep it secured with the LATCHsystem
or a seat belt. In a sudden stop or collision,
loose objects can injure occupants
or damage the vehicle.
CAUTION
A child restraint in a closed vehicle can
become very hot. Check the seating
surface and buckles before placing a
child in the child restraint.
This vehicle is equipped with a universal
child restraint anchor system, referred to
as the LATCH (Lower Anchors and Tethers
for CHildren) system. Some child restraints
include rigid or webbing-mounted attachments
that can be connected to these anchors.
For additional information, refer to
“LATCH (Lower Anchors and Tethers for
CHildren) system” in this section.
If you do not have a LATCH compatible
child restraint, the vehicle seat belts can be
used.
Several manufacturers offer child restraints
for infants and children of various
sizes. When selecting any child restraint,
keep the following points in mind:
- Choose only a restraint with a label certifying
that it complies with Federal MotorVehicle
Safety Standard or Canadian
Motor Vehicle Safety Standard.
- Check the child restraint in your vehicle
to be sure it is compatible with the vehicle’s
seat and seat belt system.
- If the child restraint is compatible with
your vehicle, place your child in the child
restraint and check the various adjustments
to be sure the child restraint is
compatible with your child. Choose a
child restraint that is designed for your
child’s height and weight. Always follow
all recommended procedures.
- If the combined weight of the child and
child restraint is less than 65 lbs.
(29.5 kg), you may use either the LATCH
anchors or the seat belt to install the
child restraint (not both at the same
time).
- If the combined weight of the child and
child restraint is greater than 65 lbs.
(29.5 kg), use the vehicle’s seat belt (not
the lower anchors) to install the child
restraint.
- Be sure to follow the child restraint
manufacturer’s instructions for installation.
All U.S. states and Canadian provinces or
territories require that infants and small
children be restrained in an approved
child restraint at all times while the vehicle
is being operated. Canadian law requires
the top tether strap on forwardfacing
child restraints be secured to the
designated anchor point on the vehicle.
LATCH system lower anchor locations -
bench seat
Your vehicle is equipped with special anchor
points that are used with LATCH system
compatible child restraints...
Other information:
When the shift lever is in the manual shift
gate, the transmission is ready for the
manual shift mode. Shift ranges can be
selected manually by moving the shift lever
up or down. To cancel manual shift
mode, return the shift lever to the D (Drive)
position...
The sensor is located on the
front of the
vehicle.
To keep the system operating properly, be
sure to observe the following:
Always keep the sensor area of the front
bumper clean.
Do not strike or damage the areas
around the sensor.
Do not cover or attach stickers or similar
objects on the front bumper near
the sensor area...